GB's Vette "How To's"...

Installing the BPP Aluminum Pedals on a '02 C5
 Visit the Breathless Performance Products website

Click on image to enlarge
 

Use your browsers "Back" button to return to this page
Here's the stock layout.

Tools required:
10 mm deep well socket, 4" extension, rachet
1/4" drill bit and drill
3/32" Allen wrench
Needle nose pliers

Using the 10 mm socket remove these two nuts holding the dead pedal mount.

Using the needle nose pliers, pull the pivot pin out of the back of the stock gas pedal to remove the pedal.

This is how the stock pivot spring and pedal assembly should look when installed back on the accelerator arm.

Holding the pedal and spring on the arm, line everything up and insert the pivot bolt, tighten using the 3/32" Allen wrench.  This can be kind of tricky.

Using the new aluminum dead pedal as a template mark the mounting holes on the box.
Drill the two mounting holes in the box using the 1/4" drill.
Attach the new dead pedal using the supplied fasteners.  Reinstall the box with the 10 mm nuts.
Your installation should look like this now.
Why couldn't have GM done this for us?  Looks like it should have now!

Hit Counter

 
 

©  2002-03 - www.gbvette.com

  This entire site and its content is copyright protected. The images on this site may not be copied or reproduced without written permission from GBVette.com

All statements and recommendations contained herein are based on information we believe to be reliable, but the accuracy or completeness thereof is not guaranteed.  The "HOW TO" section of this site is offered as a guide only.  This information is provided "as is" without warranty or any kind, either expressed or implied, including, but not limited to, the implied warranties of merchantability, fitness for a particular purpose, or non-infringement. In no event shall GBVette.com be liable for any direct, indirect, incidental, punitive, or consequential damages of any kind whatsoever with respect to the service, the materials and the products referenced in these documents.

Chevrolet, Corvette, Vette, Stingray, GM Restoration Parts, Genuine Chevrolet, The Heartbeat of America, Chevrolet Bow Tie Emblem, GM Restoration Parts Emblem, and Corvette emblems and body designs are General Motors Trademarks.  All other copyrights, trademarks, service marks, and logo's are the respective property of their holders